PDA

View Full Version : Will these rims work!?



Prospeeder
06-30-2008, 04:34 PM
I need to know ifwheels like these
http://imgs.getauto.com/imgs/ag/ga/54/14/1/1G2HX52K54U195414-1.jpg

on this 2000 ish bonneville would fit on my pontiac 6000, its a 1990 with the 115x5 bolt pattern like these, but are the offsets ok? these wont like be too far in or stick out will they? and any idea what size tires to run, i belive there 16x7 but i could be wrong. Grand prix wheels fit ok too?

85 Holiday
06-30-2008, 05:11 PM
I need to know ifwheels like these
http://imgs.getauto.com/imgs/ag/ga/54/14/1/1G2HX52K54U195414-1.jpg

on this 2000 ish bonneville would fit on my pontiac 6000, its a 1990 with the 115x5 bolt pattern like these, but are the offsets ok? these wont like be too far in or stick out will they? and any idea what size tires to run, i belive there 16x7 but i could be wrong. Grand prix wheels fit ok too?

You need to find the offset for sure. Ask the seller(etc) or someone here by chance might know. GM likes to put all that info on the inside of the wheel. If it is anything like the 97+ W-Bodys with 52mm offset then no

86euro
06-30-2008, 11:00 PM
If it is anything like the 97+ W-Bodys with 52mm offset then no

Mine fit. It mostly depends on tire choice.

Prospeeder
07-01-2008, 06:24 AM
from what im gathering i belive there a 42 mm offset, is that gonna work? whats ours? these rims are at a j/y here, and i have to get new tires, soo i want somthin besides the hubcaps. Ill bet that the axle stub sticks out too far and the center cap wont go on, right? Are spacers probably going to be needed then? and to get the rims far enough out to have the centercaps work, will they stick out too far and look goofy?

Prospeeder
07-01-2008, 10:16 PM
nobody knows?

86euro
07-02-2008, 12:09 AM
Ill bet that the axle stub sticks out too far and the center cap wont go on, right? Are spacers probably going to be needed then? and to get the rims far enough out to have the centercaps work, will they stick out too far and look goofy?

The centercaps may or may not fit on the front. The '00-up Monte/Impala caps clear the stubs, my GP wheels do not. I want to get spacers for mine, but I need to pull a wheel off to see if there is an open area between the lug holes in order to run a 3/4inch spacer in the front. If not, a 1inch or so would work. I want to run a 1.25-1.50 thick spacer in the rear to make the rear track about the same as the front. At any rate, my wheels fit and still look pretty cool even without spacers. Oh, and with spacers, they won't look goofy because they won't stick out any farther than the stock aluminum wheel optioned cars.

85 Holiday
07-02-2008, 12:50 AM
nobody knows?

FWIW stock olds crosslaces on the ciera are 14x6x40mm

Tuddi
07-02-2008, 07:07 AM
nobody knows?

If I was you... after having a few sixpacks, I'd ask Techfizzle... he'd probably give you a green "go ahead" light, along with JB weld, and you'd be set for the rest of your short life....

Other than that info, I'm not going to be very helpful...