Results 1 to 3 of 3

Thread: heater core flush tips/tricks/hints?

  1. #1
    Junior Member
    Join Date
    Feb 2014
    Location
    Michigan
    Vehicle
    1995 Transport
    Posts
    6

    Default heater core flush tips/tricks/hints?

    Update!

    Putting the Transport on the road tomorrow! Finally sold the Ford Freetyle.

    I will need to flush out the heater core, because right now I have no heat. And tomorrow's high will be 9. (Tonight a low of -4 and tomorrow night a low of -11...) I was going to tap into my water heater to hopefully help get rid of the brown/red sludge I can see in the radiator. I assume that someone added Dex Cool at somepoint making the mess.

    If you have any hints/tips/tricks send 'em my way!

    Chris
    '95 Transport SE



  2. #2
    Senior Member thesam1984's Avatar
    Join Date
    Apr 2013
    Location
    Toledo Ohio
    Vehicle
    1990 Buick Century Custom 3.3 "T-Type" sedan
    Posts
    874

    Default

    My tip is to put the car on ramps while filling the coolant. This puts the vehicle at an angle and the radiator up high, less bubbles and fill time quicker... it also compensates for poor design on some vehicles where air can get trapped easily in the motor. It also puts the radiator at waist level so theres less bending for me ( Im 6' tall)
    Roads.... Where we're going, we don't need roads.

  3. #3
    Senior Member
    Join Date
    Oct 2009
    Location
    Elmhurst, IL
    Vehicle
    1989 Oldsmobile Cutlass Ciera, 2007 Subaru Legacy GT
    Posts
    1,363

    Default

    Being that I have had to swap back and forth between water and antifreeze a bunch of times. If you want to make sure to empty the full system you can empty the radiator and fill it with water and the from the just disconnect the upper radiator hose and if your hose has enough pressure almost run it indefinitely by replacing the water coming out of the engine with the water from the hose. Run the heater to make sure you get good flow through the heater core. Once the water is clear enough for you stop the car. Empty the radiator and fill the radiator up with pure antifreeze. then just run the car with the radiator cap off and fill as needed. Running it will mix the fluid on its own. And at least with the 60 degree v6 the radiator held just about exactly 50% of the coolant in the system so you will end up pretty darn near perfect 50/50 when done.

    Of course with the current weather this may quite suck to do.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
VigLink badge